Hondata 10 Pin Analog Connector E85 & OBD2B in our wiring

& OBD2B in our wiring section)

aftermarket mounting plates and non factory locations are ok

This happens due to someone starting a car with the IAT intake air temperature sensor plug being plugged into the purge valve located at the back of the intake manifold

Manifold Pressure

please note stock knock sensors are highly unlikely to be utilized under any type of after market tuning situations and deemed unnecessary

Hondata 10 Pin Analog Connector E85 & OBD2B in our wiringThis 10 pin connector is a direct fit for the Analog side of Hondata S300 and Kpro units. Comes standard with 5 FT pigtail to be pinned and trimmed to size with the ability of reaching across the cabin directly to hardware with no splicing necessary.